Ellijay Makerspace Project Wiki
Project info, runbooks, and standard operating procedure docs of the Ellijay Makerspace
User Tools
anycubic_photon_m7_pro
Differences
This shows you the differences between two versions of the page.
| anycubic_photon_m7_pro [2025/03/06 20:19] – created sundog | anycubic_photon_m7_pro [2025/03/06 22:50] (current) – start adding setup procedures sundog | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| ===== Setup Procedures ===== | ===== Setup Procedures ===== | ||
| + | |||
| + | Generally this printer is set up with Anycubic ABS-Like Resin v2 Gray (water washable) which it loads and unloads automagically via the resin pump on the rear right corner of the printer. You can access the fill/drain functionality via the touchscreen. If there is not resin currently in the printer when you are scheduled to use it, please check in with Andrew or Sundog to get trained on making sure the printer is ready for the resin you'd like to use. | ||
| ===== Printing Procedure ===== | ===== Printing Procedure ===== | ||
anycubic_photon_m7_pro.txt · Last modified: by sundog
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
